i tired the following step but it still not working jasper not booting into xell This is what i'm using TX Coolrunner Rev C TX Nand -x J-Runner 1) Read Nand (J-Runner) 2 matching copies, made a .rar backup Nand Result : Jasper 512MB Dash Board 16202 CB 6754 2) Flashing Cool Runner Rev C RGH 2.0 used Type RGH2.0 A (Jasper) Soldered the Coolrunner to the motherboard 3) Now to write the .ECC file i used the ECC in R.I.P DGX Folder Jasper BB, wrote the ECC file using Xe Build GUI NandPro GUI Operations. But still its not booting to Xell Coolrunner info JP - open 1-2 - bridged Cap - bridged the coolrunner Green light flashes a couple of times but nothing shows up on the screen Please Help
Also u will get awfull boot times with revc u should have got cr lite but phats on rgh2.0 most of the time have bad boot times cheers Wayne
Thank you so much for helping me out You were right about the boot time, It just booted in to xell reloaded, It booted after 12 minutes Thank you so much big wayne