XPG Paddy Nov 25, 2012
To Be more precise "03X" Chip.
You need to get a chip for it, either one that will need a probe or one that you can switch.
sputnik probe is the one i used when i had the board from addz i didnt bother fitting a switch just fixed the trace that addz prepared for me .
oh and by the way m8 if you dont have a sputnik probe if yore the bloke from walsall you can pop and lend mine till you get yourself one ....as long as you bring it back :LOL:
u got a link ?
Haha Cheers man. Im wanting to do the switch way but im not from walsall
ahh no pros m8 i thought it was you theres someone on here from my area thats why i offered ..
personally id cut the trace on that drive and buy the probe for it ...you can always use it time and time again ..
Oh right sweet is all I need is the probe and a fibre glass pen? U got a tut?
i dont have a tut made but im pretty sure theres a great tut on here or if i rember right jungleflasher tut shows the exact points on the board ..
Just found out you can Kamikaze a mxic Drive that saves me getting the probe thing don't it I got the drill bit
why kamikaze it if possible too dangerous for such a simple operation open jungleflasher view the correct points to scratch off i used a scalpel no need for a scratch pen cut the trace ..
providing youve already got youre key read and loaded into f/w 32 tab and the appropriate LT firmware send spi unlock probe the point next to the cut wait for the beep usally instantly BAMM unlocked then press write providing it all writes correctly and authorises outro about three times take back to console and test ..if all good what i then do is re intro it lock the drive dab of solder to seal the trace cut outro drive again fit back to console and enjoy ..
Separate names with a comma.