easy read the info in the tool here Xextool will tell you how to load the file into ida. If you don't have ida, then load it into the disassembler you are using with the same parameters. An example of the load info xextool gives you is as follows: Load basefile into IDA with the following details DO NOT load as a PE or EXE file as the format is not valid File Type: Binary file Processor Type: PowerPC: ppc Load Address: 0x92000000 Entry Point: 0x9201DD38
The op was not asking about xextool, it was XCE, which is confusing how to set BP on. Have not done it in a while however i know you need to have VS connected to console while setting bp on tool. So really doesnt save much time.