Sup lads Well as title says i think its important for reference to setting up these new CR3 Lite chips from TX I'll kick it off had a Jasper RGH2 to do and its been a Byatchhhhhhhhh but finally sorted it today after allot of pissing around My setup went like this LK1 Bridged LK2 Open LK3 Open LK4 Open Switch settings S2: 5 ON All the rest off S4 All off Boot timings great boots everytime Bout 20 sec's Please continue with this tread and update it with your setups when doing your RGH 1 or 2
I did a Falcon today with CR3 Lite. (RGH1) LK1 Bridged LK2 Bridged LK3 Open LK4 Open Switch settings S2: 5 ON rest off S4: All off *Insta-Boot 1 flash of the CR3 Lite and boom
Falcon RGH 1 Wired in like a normal RGH 1 diagram Lk1 Closed Lk2 Open Lk3 Closed Lk4 Open S2 Switch's 1 & 5 All the rest Off Instant glitch Happy days
Getting no green flashing light with these settings & a faint green light but no boot with: Lk1 Open Lk2 Open Lk3 Closed Lk4 Closed :S
...sorted it, ECC wan't right for it so I reflashed with the right one RGH1 rather than the RGH2 I was prompt (my fault). Falcon RGH1 LK1 - Short (Disable Crystal) LK2 - Open (Enable 10 Ohm on CPU_RST) LK3 - Short (C15 Enable) LK4 - All Open (Slim Settings) Switch 5 on only. Insta-boot
RGH 1 Falcon board LK1 Closed LK2 Closed LK3 Closed LK4 Open S2 switch's 1,5 on all others off instant glitch