My Jasper is dead after attempted RGH. First time this has happened to me I was able to dump the nand twice and save it I was able to create ecc When i went to write ecc, nothing but errors Console will not turn on 256 Jasper I tried CMD nandrpo lpt: -e64 0 3ff and all i get there is flash controller not detected My soldering is good, because i was able to read the nand easily. I have not desoldered anything Everything i see is old and outdated, asking for certain files that are in the data folder of JRunner, but those files don't exist on version 7 of Jrunner Any help would be appreciated..thanks
First of all your RGH is not dead therefor you don't need a guide on how to recover a dead RGH. No flash controller detected is 99% of the time caused by bad soldering(could also be a bad LPT cable) and 1% of the time by a corrupted nand(nand itself not the image).
write your original nand back to the console and set your coolrunner to prg and see if the console boots.
Ive had this problem with my jtag same exact problem and when i hooked coolrunner up it still was unresponsive. What you have to do for this is. 1- resader all wiring for the rgh/jtag mod (all wiring) 2- wire your coolrunner in 3- see if it wakes tha console up enough to get a nand read. 4- flashback to a previous nand or make a new clean one and make sure its good. Thats what i did to make my personal console bootable
