[HELP] find heath bar offser with XCE tool

Discussion in 'Trainer Creation' started by 740headshot, Nov 9, 2014.

  1. 740headshot

    740headshot Developer XPG Developer
    15/47

    whats up guys how can i find heath bar offset with XCE tool2? please help
     
  2. XP

    XPGXR Newbie
    0/47

    Depends on the game and what memory sections it uses,

    Make sure you got full health before you start

    Then try setting address at the top to 0x40000000 - 0x50000000

    Then check float and int32 box at the top of the tool


    Hit the int button on the left to start the search wait till it finishes then in reduce to rage boxes put

    1 - 1000000 and hit the reduce to range button this will narrow down your search

    Once finished get hit by an enemy or some other method to make the bar decrease a little bit

    Then hit the dec button on the left

    To search for any values that have decreased

    Repeat again

    Repeat again

    Repeat again and so on etc its not hard


    If you have away of increasing your health as well as decreasing your health in game

    Then do same as above only do

    Get hit search decreased value

    Use what ever method you got in game to increase your health then

    search higher with the inc button

    Until you find what you looking for

    If you dont find what you are looking for move your search to a different memory section
    By putting a different address in the top etc
    0x50000000 - 0x60000000
    Or
    0xC0000000 - 0xD0000000
    Etc
    Simple!
     
  3. 740headshot

    740headshot Developer XPG Developer
    25/47

    ok thx for your help
     
  4. system12

    system12 Rookie
    15/47

    I trying use the xcetools 2. How freeze the box during i dumping memory? I use it peek poker! Xcetools 2 is dumping the memory but not found nothing! Why? I use xbox side xbdm.xex plugin. Xcetools2 needed the devkit kernel?

    Thx the help!
     

Share This Page