Xecuter CoolRunner - Slim Install (QSB)

ADDZ Dec 22, 2011

  1. ADDZ

    ADDZ ( * Y * ) Staff Member XPG Founder
    0/47

    Joined:
    Dec 12, 2010
    Messages:
    15,914
    Likes Received:
    6,681
    Trophy Points:
    565
    Location:
    Behind you sniffing your hair!
    Console:
    Playstation 4
    Xecuter CoolRunner - Slim Install (QSB)



    I have made this into 1 large image so its easy to share around.

    We recommend that the CoolRunner is programmed first with the correct jed/xsvf file before installation.
    ( Found here: CLICK HERE )

    Use the wires that are included with the CoolRunner kit. They are cut to optimum length. Make sure the switch is set to SLIM (Yes I had to say this as you'd be surprised as to how many people would ask lol)

    [​IMG]

    This is how the position of the CoolRunner looks like when installed to a slim.

    [​IMG]

    Note: CPU_RST (D - BLUE) IS 50 CM LONG - THIS IS INTENTIONAL DO NOT CUT. SIMPLY LOOP THE WIRE LIKE SO:


    [​IMG]
    Tip


    A slim should not take longer than 10 seconds to boot. If it does take longer then we suggest changing the length of the CPU_RST wire. First try 40cm then 30cm and go with whatever the best results are. Only do this if you are successfully glitching to Xell reloaded. This is not meant as a fix for non booting consoles - this is boot time fix only.



    [​IMG]

    Added:

    Another troubleshooting tip: Switch the CoolRunner to Phat and see if the times improved - this works for some [​IMG]

    This tut was by the amazing Uber Geek from T-X.
     
  2. xA

    xArTiiK Newbie BANNED
    0/47

    Joined:
    Nov 24, 2012
    Messages:
    54
    Likes Received:
    1
    Trophy Points:
    0
    Console:
    Xbox
    there a site where I can buy the jtag?
     

Share This Page

Close