The following ceramic caps can be used. Do not use an incorrect value than what is stated or you will damage your DGX hardware. Remember to cut those ceramic cap pins short ! Corona A (Cor_A) - 10pf, 22pf, 30pf or 47pf Corona B (Cor_B) - 68pf, 82pf or 100pf Corona C (Cor_C) - 10pf, 22pf, 30pf or 47pf Trinity A (Trin_A) - 10pf, 22pf, 30pf or 47pf Trinity B (Trin_B) - 10pf, 22pf, 30pf or 47pf Trinity C (Trin_C) - 10pf, 22pf, 30pf or 47pf Trinity D (Trin_D) - 68pf, 82pf or 100pf Here are the cap solder points for each DGX. Only one cap at a time can be used - do not use a combination of caps. Do not use the wrong value cap on a timing file (i.e. Trin_A cannot accept 68pf, 82pf or 100pf - see above chart). make sure you trim down the legs of the cap when soldering to the PCB. SOURCE: TX forums Great Work as always