Rgh and lt+3.0

i played the game from dvd

 

try playing game from hdd mate it might make differance

 

ok thanks but I just want to know what's the problem I played the game (assassins creed 3 ) before rghing after that I tried to play the game but it froze once in the gameplay twice in intro so please help I heard its gpu but I don't know

 

Could be overheating if its freezing up.Probably needs repasting with thermal paste and the clamps replacing.

 

apply pressure to your gpu like putting your foot on it with a little bit of pressure. it might need repasting with thermal compound but if it worked before you rgh'd it, its more likely you haven't tighten the heatsinks enough but don't tighten to much as it will show a fake RROD. If fake RROD shows up just loosen the screws slighty

hope this helps

t3

 

well my game worked on my flashed lt 3.0 Xbox 360 before being rghd

 

What motherboard and what RGH method did you use?

 

my mobo is falcon My method is rgh 2.0

 

hey I just wanted to add something it happens with all my games I just tried two of my games

 

If it's falcon did you change the power mode in your SMC?

 

sorry but what is power mode and smc I'm a little bit noob

 

ok sorry but what is smc I just know power mode

 

the problem is not in my rgh because it works good my problem is in the flashed drive because when I play a game from it it freezes in gameplay and also after I installed xexmenu I tried to start my game from DVD but same issue

 

can anyone please help

 

ok I want add something know my games know only freeze in gameplay

 

does any one know a fix for this because I didnt rgh it I payed for someone to rgh it

 

Okay..seriously dude. You keep spamming the damn thread. Have patience and you will get your answer. If it's freezing on games, and if it is indeed a falcon as it's already been stated in this thread. You'll need to edit the power mode in the SMC. This has been proven to solve a lot of issues.

Open your NAND up in J-RUNNER > Tools > SMC Config Editor, try and change your Power VCC to 8555 (Leave Stock and try below and only change this if the below configs don't work)

Then try these to see what one works best for you..

8080
8180
8280
8380
8480

These are findings and tests we done over at Team-Xecuter Forums and have proven to be effective.

Try them out. If that doesn't help. Must be a wiring issue.

 

ok thank you I know I'm a little paitience I'm sorry for spamming but I was little nervous and thanks I will try this method thank you

 

Thanks Bro for the great info.